Buffalo TS-XEL/R5 NAS Firmware 1.76 Windows 7 driver download - Windows 7 Download
Buffalo TS-XEL/R5 NAS Firmware 1.76
| File Size: | 349.80 MB |
|---|---|
| Platform: | Windows XP, Windows 2003, Windows Vista, Windows 2008, Windows Vista 64 bit, Windows 7, Windows 7 64 bit, Windows 8, Windows 8 64 bit, Windows Server |
| Date added: | February 19, 2022 |
| Downloads: | Total: 26 | This Month: 1 |
| Manufacturer URL: | Buffalo |
Download Buffalo TS-XEL/R5 NAS Firmware 1.76
Buffalo TS-XEL/R5 NAS Firmware 1.76 driver for Windows 7
Bug Fixes:
- [SMB] Modified to patch a vulnerability (CVE-2020-25717).
Caution:
- Please consult your local technical support representative if you experience any problems caused by this firmware update.
- Do not turn the unit off until the update is finished. It will take several minutes. You will receive a message when the update is finished.
- USB drives are not mounted automatically after a firmware update. To mount them, unplug and then reconnect them.
How to Use the Updater:
1. Connect the TeraStation properly and configure the TeraStation and a computer to run the updater on the same network subnet. The subnet masks should be the same and the first three numbers of the IP addresses should be the same. The last number of the IP addresses should be different.
For example, if the IP address and subnet mask of the computer are
" 192.168.0.10 , 255.255.255.0 "
and the IP address and subnet mask of the TeraStation are
" 192.168.1.150 , 255.255.255.0 "
then the updater will _not_ work properly.
In this case, reconfigure the TeraStation's IP address and subnet mask to
" 192.168.0.150 , 255.255.255.0 ".
Then they will be on the same subnet and the updater will work properly.
2. Close all applications. Also, stop or exit any firewall software.
3. Extract the downloaded file and run "TSUpdater.exe". When a TeraStation is detected, an update window will open.
4. Select the TeraStation to update if multiple TeraStation are connected.
5. Click "Update" and enter the TeraStation's admin password.
6. Click "OK".
7. Transferring and updating the firmware will start. Wait until it finishes. The info LED will blink during the update.
8. When the update finishes, a message will be displayed.
About HDD Firmware:
Updating the HDD's (Hard Disk Drive) firmware version can fix various problems that might occur, enhance some of the features available or add support for new ones, and improve the unit's overall performance.
However, as this task can be very risky, applying a different firmware is recommended only when the newer version specifically resolves an issue that bothers you, or brings about changes that you can make full use of.
In addition to that, make sure you perform this task only in a steady power environment (such as the one ensured by a UPS unit).
As for the update process, due to the wide variety of HDDs and various methods provided by each manufacturer for installing a new firmware, it would be best if you carefully read and understand the installation steps.
That being said, if you consider updating the HDD to this firmware version, click the download button, and make sure you read the installation guide before initiating the upgrade. Moreover, constantly check with our website to stay up to date with the latest releases.
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.